Warrior W-1 CEMENT STRENGTHENER

• Improved bonding strength by 2 to 3 times to 30.57 kg/cm2. Especially good for bonding
• homogeneous tiles, granites and marble tiles, and to prevent staining.
• Increased flexural and compressive strength by 40% to 100%. Compressive strength to 56.00 N/ mm2 . Flexural strength to 10.00 N/mm2 . (ASTM C 39). 
• Quicken cement setting time. Reduced surface cracking and dusting, forming a very tight seal. Good for wall plaster, wet area and swimming pool waterproofing.
• 10 to 20 times more resistant to oil, salt water, chloride, acid and vapour penetration.
• A feature particularly important in steel reinforced concrete structure.
• Improved plasticity and flow (ASTM C 124-71), easier to work with, reduces porosity.
• W1 CEMENT STRENGTHENER is deemed to be suitable for use in contact with water intended for human consumption tested against SS375 : 2001.

1. The amount of water needed is 24 % by weight of cement.
2. This can be replaced totally with 24 % or lesser of W1 for optimum performance.

1. Dilute W 1 + Water = 1 + 1 by Volume, before adding into the Cement.
2. It will waterproof and bond tiles very strongly onto glass, glazed tile, steel and wood. Fine silica sand of 0.5 mm diameter can be added for grouting the tile joints.

1. Dilute W 1 + Water = 1 + 1 by Volume, before adding into the Cement.
2. Thinly brush a coat the old tile surface with W 1 + Cement to about 1.0-mm. While it is still wet, bond on the tile.